Steel Bar Straightening and Cutting Machine Safety Advice

 

Steel bar cutting machines and straightening machines are pieces of heavy construction machinery that work with bulky, heavy and potentially dangerous metal objects, so it is important that the devices are operated within strict safety requirements. There are several rules that operators should follow to ensure that the machines are safe, including:

steel bar straightening and cutting machine

1)The length of the table/work surface should be appropriate for the length of the material to be processed.

2)Before the operator starts using a cutting machine they should check the cutter, the knife bolt, and the shield. They should also check that there is sufficient gear mesh clearance, and that the cutter gap is appropriate. The operator should then check that the machine runs appropriately when it is empty, and only then attempt to use it to cut steel.

3)The machinery should not be used if it is not running at the correct speed. The machine should only be fed using the appropriate techniques described in the documentation. Double-handed feeding, especially sub-leaning, is prohibited for safety reasons.

4)Take care not to exceed the mechanical shear strength of the plate diameter, and ensure that the cross-sectional areas of steel bar being cut are always within the prescribed limits for that type of steel.

5)When cutting low-alloy steel, make sure that you are using the correct hardness of cutter.

6)When cutting short pieces of material, make sure that your hand does not come anywhere closer than 150mm to the cutter. If you are cutting items shorter than 500mm, use a short steel tube or a jig to hold the material, so that the hands are protected.

8)Do not use your hands to remove debris from the cutter. Make sure that the cutter is completely switched off and disabled before attempting to clean it.

9)If the machine makes unusual noises, ceases to cut straight, or otherwise behaves unusually, immediately cease use of it and report the issue to an authorised repair person.

10)To clean steel cutting or straightening devices, cut off the power, use a steel brush to clean the device, and then apply the appropriate kind of lubricant.

11)For hydraulic machines, check the oil levels regularly. Operate the device in no-load state, and if necessary drain the cylinder of air for maintenance. Make sure that the oil drain valve is tightened in a clockwise direction. Wear insulated gloves when working on or around such devices.

12)Always wear appropriate hand, eye and ear protection for the environment that you are working in.

13)Do not operate heavy machinery when tired or under the influence of drugs or alcohol.

14)Do not allow untrained personnel near heavy machinery while it is in use. If someone visits the plant, supervise them when they are in the machine room.

steel straightening and cutting machine

The above are the main rules for safely operating steel bar straightening and cutting machines http://rebarprocessingequipment.com/steel-bar-straightening-cutting-machine/. Be sure to read the operational manual for the device that you are working with, and follow any instructions that the construction machine manufacturer gives, as there may be some specific to that device. Want to find reliable supplier? Click here http://rebarprocessingequipment.com/!